供应hydro-therapy massage bed,盐浴 

一、功能说明:
1、花洒：用于进水和喷淋；
2、进水瀑布：用于进水；
3、按摩水疗垫：有助于对人体进行水力按摩，增加人体舒适度；
4、分水阀：控制花洒和瀑布的开关，调节水量大小；
5、热水阀：调节热水水量，控制水温；
6、冷水阀：调节冷水水量，控制水温；
7、气动开关：用于打开和关闭水泵及喷咀；
8、洗头盆：用于冲淋头发；
9、头枕：用于头部护垫；
10、去水阀：用于排水；
11、回水阀：用于水循环；
12、按摩喷咀（单孔）：用于水力按摩；
13、按摩喷咀（多孔）：用于水力按摩；
二、工作程序:
1、工作前先接通水电，放水清理水床，将水床中余水放干；
2、将排水开关关闭，调好冷热水温，开始对水床放水，水量必须超出按摩喷咀，方能启动水泵电机启动开关，此时按摩喷咀开始喷射出水；
3、当水床中水量下降至按摩喷咀下2、3cm时，必须打开进水开关，一边加水，一边喷射按摩，避免因缺水而损坏水泵电机；
4、放满水时即可启动臭氧消毒机对水产中的循环水进行消毒，使用完毕时，立即关闭臭氧消毒机；
5、如要进行振动按摩，只需打开振动按摩控制面板上的开关即可，振动频率可依据各人适应力加以调节，使用完毕，即关闭振动按摩器开关；
6、每用完一次水疗床，请将水床排水阀打开，放完余水，并放水清洁，清洗完毕即关闭水源及排水阀，以备下次使用。

hydro therapy massage bed

1.sprinkler: for water and spray;
2.influent Falls: for water;
3.massage spa pad: the human body to help Jacuzzi, increased human comfort;
4.sub-valve: the control of showers and waterfalls of the switch, regulating water size;
5.hot water valve: regulate water quantity, water temperature control;
6.cold water valve: cold water regulation, control water temperature; 7.pneumatic switch: to open and close the pumps and nozzle;
8.Shampoo pots: for Chonglin hair;
9.head: for the head Hudian;
10.to valves: for drainage;
11.return valve: for the water cycle;
12.massage nozzle (single hole): for Jacuzzi;
13.massage nozzle (porous): for Jacuzzi;
Second, the working procedures:
1. before the work connected to water and electricity, clean water water bed, water bed will be put in the water more than dry;
2.will switch off drainage, good for hot and cold water temperature, water beds began to water, the water must go beyond massage nozzle, pump motor can start start switch, then began spraying water massage nozzle;
3.when the water bed in the water dropped to massage nozzle under 2,3 cm, they must switch to open water, while water, while jet massage, water shortage and avoid damage to pump motor;
4.to take over at the start of ozone water disinfection of the fish in the water cycle disinfected after use, the immediate closure of ozone disinfection;
5.to vibration massage, simply open the control panel vibration massage on the switch to, based on frequency can be adjusted each adapt to the use of the end, that is closed vibration massage switch; 6.each spent a spa bed, water bed should be drainage valves open, end-over water, and clean water, clean finish that is water and drainage valves closed, to prepare for the next use.

Technical parameters:      

Type: ST-198      Voltage: 100V-240V/AC      Frequency:50-60HZ  

Maximum power:350W     Package Size:2150*1050*600mm

Material:oversea  import material